Psion OMNII Manual de usuario Pagina 32

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 358
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 31
Chapter 2: Basic Operation
Resetting Omnii
16 Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
Switching Omnii Off
To switch off Omnii, press the [FN] key and then press and release the
[ENTER/Power] button. Omnii will automatically enter the Suspend state.
2.4 Resetting Omnii
To perform a warm or cold reset, you can access the menu by going to Start>Shutdown. Al-
ternatively you can use the keyboard shortcuts described below.
Important: Turning off the hand-held does not result in a complete shutdown; rather,
the unit enters a power-saving, “suspend” state. When Omnii is turned on
from suspend state, operation resumes within a few seconds.
Important: If the word ‘FN’ is displayed underlined in the taskbar area at the bottom
of the screen, this key is locked “on” and Omnii will not switch off. Press
the [FN] key twice followed by [ENTER/Power] to switch Omnii off.
However, if you’ve set the mode to “Lock” (see “Keyboard One Shot
Modes” on page 95), Omnii can be turned off even when the [FN] key is
locked ‘on’.
Note: If your Desktop is switched to the PsionVU Shell (refer to “The PsionVU Desktop
Shell” on page 70), resetting the unit is done solely by use of the keyboard
shortcuts.
Vista de pagina 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 357 358

Comentarios a estos manuales

Sin comentarios